sending unit question

jwilly · Post by **jwilly** » February 28, 2010, 11:11 am

I am about to install a early Bronco II gas tank in the rear frame of my 65 F250 and need to know if anyone tell me if the sending unit for this will work with my existing gauge. any info is greatly appreciated
thanks ,
joe :

64 f100 · Post by **64 f100** » February 28, 2010, 12:20 pm

I hadn't gotten that far with this and haven't done any research but Iam also interested in the answere. Even our gas tank sending units didn't work all that greaat when most are sued, but I see dnot reason these won't work, as these are basically the same. Resistance may be different, which would be the only reason I could think of. but a little obseervance and you should be able to figure it out by filling it up, and watching the guage. You can add any etra if need, with trial and error or just install a pontentiometer and dial it in and measure to find your resistance needed.

Rich

jwilly · Post by **jwilly** » February 28, 2010, 4:51 pm

I haven't bought the bronco II sending unit yet , that's why I need to know if it will work or what other options I have
joe