240/300 valve covers and plates

slickmainer · Post by **slickmainer** » April 15, 2010, 12:55 pm

I found this site while searching for valve covers. looks pretty sweet.

http://www.hawesengineering.com/pages/products.html

Also looks like he is working on some finned ones in the projects section.

Bigfoot21075 · Post by **Bigfoot21075** » April 16, 2010, 9:31 am

Looks cool but no prices?

Post by **Casey 65** » April 16, 2010, 11:50 am

The covers are machined from solid to resemble a cast Offy component. They have a recessed pocket on the back to accept the stock gasket and utilize the stock rubber grommet/ washers and hardware for fastening.

The Lifter Covers are priced at $185 each
Matching Fuel Pump Block off plates available for $25 each
Combo Set (Lifter cover plus block-off) $200

A machined matching valve cover (1 in taller) is available for $750. (machined from solid)
Since machining a valve cover isn't cost effective, I'm currently working on a pattern to have a valve cover cast.

Shipping cost = West of Mississippi = $5, East of the Mississippi = $10. Send me and email with the ship to address and I'll give you a total with shipping for outside the continental US.

slickmainer · Post by **slickmainer** » April 16, 2010, 12:01 pm

is that your place Casey? Looks sweet. I'll email you questions

MadMaxetc · Post by **MadMaxetc** » April 17, 2010, 12:11 am

Looks cool.

I was thinking something more like the X patern like the original.

PS: What software do you use? Looks like solid works.

Post by **Casey 65** » April 18, 2010, 1:01 am

not mine. I contacted him to get prices.