65 axle shaft seal leak - need help

[ClanCassidy]

Hi guys,

65F100, 2WD, 9" rear, orig. engine was a 6 cyl.

I replaced both seals on the end of rear axle tubes and I still have a leak. Closer inspection of that axle shaft shows the area where the seal rides has worn down a few thousands and is lightly pitted.

Do they make replacement seals with more offset (inwards) that part of the axle shaft looks like brand new. I've also heard I can replace the stock bearing with a sealed version (oring on the outside and seal inside).

Any advice ? Do I just need to find a new axle shaft ?

thanks.

[DV65CustomCab]

There is a product, and I forget the exact name, that is basically a sleeve you put onto the axle that covers the worn area. I think they may have been made by Bowman, an automotive hardware supplier. I used to sell these when I worked in the business. You may want to ask your local NAPA or other good parts store about them.

[mwilk1]

ask your local parts guy about axle savers. I think that is what your looking for. MIke

[cdherman]

Check the vent and make sure its not plugged. Plugged vent will build up pressure and push oil through perfectly fine seals.