Thanks Rich!
Well this is all actually on my freshly rebuilt Fairlane.
So far I have the cooling system flushed out with a hose.
The rad is out, I ran water through the block and the heater core.
I used some marine clean to try to break down the oil but its pointless.
Last night at 2am I dropped the pan and drained it. No sign of water when I poured it out. I then put a couple bolts on the pan and called it a night but not after I P.blastered the converter plug with penetrating fluid.
This AM I tried to pull the torque converter plug but I managed to strip the head off

I then rotated the mill over by hand to see if it had two. No deal. I then dropped the pan, it was about half full of trans fluid.
I decided to change the filter while I was in there and as I removed bolts some water spilled out. About 1/4 of a dixie cup or so.
The plan now is to button it all up, get the aux cooler in place then run a line line into a bucket of clean fluid and run it into an empty bucket until the old stuff is expelled. I'll then hook up the cooler and drive it and hope to burn off any moisture left over.
Thats about the best i can come up with.
Anything in the converter water will kill?
I suspect the pump may already be dead.
Any other ideas? This is new territory for me. Now you wanna talk wiped camshafts and I'm all about it
