Man I am generating questions by the minute.
The PO used a Painful wiring system. spliced, hacked and thousands
of butt connectors
Its going to take me days to figure out whats wired where.
We are going to have a rust discussion soon. I need ideas on deterring and repair. Ohio is hell on metal.
The single resivoir master cylinder is going to keep me up at night.
Ill need a great swap page. I may swap the MC then later do a disk swap.
Next up, seat belts. What did you guys do? I used wesco 3 point belts in my Fairlane. Saved my life in my crash. Yeah, Ill do that again. No idea where to attach yet though.
I want to pull the rear bumper. I love the rolled pan look. Unfortunatly its the only nod to safety on the whole truck.
The engine refuses to idle well.
Its a reman AutoZone holley 3310 Mystery CFM
Compression test, vac test and timing checks tomorrow
The tie rod ends roll front to back when my buddy turns the wheel. No idea if thats normal.
This thing have kingpins? How do you know if they are bad.
I have a terrible binding clunk when turning on the outboard wheel on both sides. No idea what that is. Sounds like the wheels hitting the fenders. They're not.