352 and dakota crossmember

[cwmoss]

just set my 352 in ready to build my motor mounts,looks as though the engine sits to nose hi,i always thought that the carb flange should be level when the truck sits level,but then again not that sure any hints and tricks.Thank you all

[557f1]

That's how I do them,
Have the car sitting at ride height and I put a spirit level on the flange of the manifold ,set it front to back and then left to right.
Darren

[MadMaxetc]

I usualy set my engines at 5° nose up. This usualy levels out the carb. But more important is that the engine angle needs to match the pinion angle one the rear end. This will balance out the u-joints and help minimize vibration.

[ Post made via Android ]