Indy63's 63 build... in Indy

A place just for our project & build threads.

Moderators: Casey 65, Kid

Post Reply
Indy63
Posts: 49
Joined: February 10, 2013, 9:08 pm

Indy63's 63 build... in Indy

Post by Indy63 »

I got this truck as a project in trade for an old Honda Shadow - it included a somewhat complete '63 Custom Cab and front clip on a rolling '63 frame with what I'm guessing is a later '70s flareside bed, a '69 302 with a 4 speed toploader, a healthy dose of "rat rod" as the guy called it, and a bed full of stuff the guy had collected or torn off the truck. It's pretty solid for a truck its age in Indiana, probably because it hasn't been plated since 1980. Major rust is limited to a nickel-sized hole in the roof, the usual core support and hood rot, and the rear fenders have some holes around the bottom. No big deal. "Throw some king pins in it, replace the front wheel cylinders, and you'll have yourself a driver!" He even delivered it to the driveway. I was ready to get out of riding and must have had my blinders on.

Original plan: replace the kingpins, discs on the front, fix a couple minor rust spots, do a quick paint job, throw some wood in the bed, and drive it.

For those not familiar with craigslist rat rods, "Rat rod" apparently means no front brake lines (new hard line on rust-filled original MC routed to rear only), no shocks, crappy S-10 power seats (not hooked up, but bolted to the floor with 3" long shoulder bolts and a handful of washers) with vatozone covers, hacked wiring, a metric ton of booger welds warping the frame to hold up a universal pipe crossmember that positioned the engine about 3" too low and centered, and rusted-out headers that hung 3" from the ground, wrapped around the crossmember, and hit the axle and bent tie rod. Oh, it was lowered by pulling all but 3 leafs out of each side on the front and flipping the rear over the springs without a notch.

Oops.

New plan: undo the "rat rod", make it safe and comfortable to drive, and make it presentable - all while staying within my original budget of $2k. Since the frame and front suspension no longer gave me a warm-fuzzy, I introduced it to the reciprocating saw and am wrapping up a '79 Trans Am clip swap I snagged for $50. Not everyone here will like it, but I'm doing it cleaner than most (no frame stacking/ butt welding) and at least I'm keeping the 302, toploader, and 9" - not necessarily out of brand loyalty, but because they work, I can make them fit, and I already have them. I'm making up the rest as I go.

Everyone likes pictures, so I'll take some this weekend and post them up as I try to document this build better than others I've done in the past. I don't have any before pics, but everyone here knows what a primer-gray flareside slick sitting on the bumpstops looks like.
rickairmedic
Posts: 1394
Joined: July 19, 2006, 9:27 pm
Location: Louisville,Ky

Re: Indy63's 63 build... in Indy

Post by rickairmedic »

Indy welcome to the club . You will find as long as you have a Ford motor under the hood most here are not picky on how you suspend your slick and there are a few members with Camaro clips under their trucks so your clip will fit in fine :D.



Rick
if it aint broke fix it till it is :D
Post Reply