1965 F100 Dash power rectifier power to? From?

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

Post Reply
RRTEC
Posts: 111
Joined: October 27, 2015, 3:57 pm

1965 F100 Dash power rectifier power to? From?

Post by RRTEC »

My truck has a new "painless" harness, it has wires to all the guages but no wires to the rectifier. Therefore my gauges do not work. Am I wrong to assume that I can tap in to any switched 12V and run it to the rectifier to power up my guages?

Thanks for any advice.
User avatar
unibody madness
Posts: 2147
Joined: December 4, 2008, 4:33 pm
Location: Paradise,CALIFORNIA 95969
United States of America

Re: 1965 F100 Dash power rectifier power to? From?

Post by unibody madness »

a fused, switched, hot wire should do the trick.
Turk build thread at:
http://slick60s.com/viewtopic.php?f=32&t=18944

It does not matter what you think, it only matters what you do about it!
User avatar
Toyz
Posts: 4334
Joined: March 22, 2011, 6:23 pm
Location: Baja Houston Taxes
United States of America

Re: 1965 F100 Dash power rectifier power to? From?

Post by Toyz »

The rectifier is a pulsed voltage regulator. You will need to run a full battery voltage switched source as you mentioned; and will also need to run a wire from the output of that IVR to each gauge, with the exception of the ammeter. If you have tested the gauge circuits by either a direct ground or introducing full battery voltage, you may have damaged gauges and/or IVR.
Paul
The Ford Orphanage
Life's too short for boring vehicles!
My quest to develop a universal solvent is held up by the lack of a storage container.
Paul
RRTEC
Posts: 111
Joined: October 27, 2015, 3:57 pm

Re: 1965 F100 Dash power rectifier power to? From?

Post by RRTEC »

I'm really unsure what was done, as the PO worked on the harness. I do know the rectifier was grounded to the chassis when I took the cluster apart. Super rigged and obviously no understanding of the purpose of the rectifier.
bruceandersson
Posts: 906
Joined: August 12, 2009, 9:44 am
Location: Ohio

Re: 1965 F100 Dash power rectifier power to? From?

Post by bruceandersson »

You not only need to power the rectifier, but make sure it is providing the power to the gauges. The ground for the rectifier comes from its mount to the speedo.
Post Reply