Ignition Timing vac/idle

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

User avatar
Toyz
Posts: 4334
Joined: March 22, 2011, 6:23 pm
Location: Baja Houston Taxes
United States of America

Re: Ignition Timing vac/idle

Post by Toyz »

One more comment and one more question! You mentioned the carburetor screen; you may want to get rid of that "vapor" hose for fuel supply and get an ethanol-rated hose.
Are you checking actual engine manifold vacuum, or another source? Your results as to vacuum under load just don't seem to jive for manifold vacuum.
Paul
The Ford Orphanage
Life's too short for boring vehicles!
My quest to develop a universal solvent is held up by the lack of a storage container.
Paul
RRTEC
Posts: 111
Joined: October 27, 2015, 3:57 pm

Re: Ignition Timing vac/idle

Post by RRTEC »

I am checking vacuum at the manifold vacuum port.

I am continuing to work on it. I did end up swapping the distributor etc. to the HEI to at minimum rule them out. Went well. Although the symptoms are the same. So that means my distributor and duraspark were fine. So I can go back that route.
BobbyFord
Posts: 290
Joined: December 12, 2007, 8:58 pm
Location: So Cal

Re: Ignition Timing vac/idle

Post by BobbyFord »

I had a customer with a similar condition. Fresh rebuild that liked a lot of ignition timing. Turns out the person that rebuilt the motor used an adjustable crank timing gear and installed the cam 4 degrees retarded. Just a thought.
Post Reply