So- after a year long of not doing much on the truck wrongbed, I am seriously considering switching to a flare side. I've mentioned it before but I am really really digging on what to do. I have always been a fan of a flareside- my first truck was a 99 ranger v6 flareside with manual transmission.
Through a contact on FB and YT, I am going to contact a guy in Ohio today who has a late 50's ('59 or '60) F100 flare side looking to trade beds. He wants a style side to go on his truck, and I am wanting a flare side. If his is nice enough- I would do an even trade. Just need to trailer it out to PA and do a switch.
My style side has a stamp on the inside fender dating it to Dec 1962. I still have no bed floor in it, and haven't installed the rear flat patches yet. I just haven't gotten the gas to do this project. Not that I bit off more than I can chew- just not really what I want.
Can a short flare side from that era of truck fit on my truck? Visa versa as well. Can my bed fit on his truck? I am sure it could take some modifications- is it possible?
I have been looking at buying new panels but dang it is expensive! over 2000 for a full kit and oak planks.
Please let me know. Thanks!


