hood issues

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

Post Reply
User avatar
unibody madness
Posts: 2147
Joined: December 4, 2008, 4:33 pm
Location: Paradise,CALIFORNIA 95969
United States of America

hood issues

Post by unibody madness »

I did a search but was hoping for a basic approach to hood hinge alignment.
I realize that the passion and detail among the group exceeds the knowledge of most body shops. They could not not manage to align hinges and hood, after a great job of body work and paint for the price.
They sprung my driver side hinge that was in great shape, and wanted a basic how to on where to start before I ruin the replacement. Right now hood is off to the drivers side and although it clears when closing it scrapes when opening.
John
Turk build thread at:
http://slick60s.com/viewtopic.php?f=32&t=18944

It does not matter what you think, it only matters what you do about it!
User avatar
Roger Carter
Posts: 730
Joined: July 5, 2008, 7:11 pm
Location: Corbett, Oregon
United States of America

Re: hood issues

Post by Roger Carter »

When I install a hood I try to set it as high and as far forward as possible, as a starting point. This usually eliminates the hood contacting the cowl. Once the hood opens and closes without contact I then set gaps by "creeping up" on the desired gap.
I also like to leave the latch off until the hood is where I want it. You don't want an improperly adjusted latch dictating where the hood rests.
It goes without saying that bent or sloppy hinges make this task near impossible.

I "fit" the hood to the cowl first, since the cowl is fixed. Then I proceed to fit the fenders and header to the hood. Quite often I have found it necessary to shim the core support to get decent fits for the fenders and header.

Remember, start any panel fit by fitting to the fixed piece and by starting big and working to close the caps.
A strip of masking tape along any potential contact points can save a lot of frustration.

A buddy, a pile of shims and tons of patience will make the job a bunch easier.

Hope this helps. Good luck.
Roger Carter
bruceandersson
Posts: 906
Joined: August 12, 2009, 9:44 am
Location: Ohio

Re: hood issues

Post by bruceandersson »

The biggest issue I've often seen with alignment is the height of the back of the hood. They tend to be higher than the cowl. You can fix this by using a wedge shaped shim with the larger end towards the front. This effectively lowers the pivot point when shut.
ICEMAN6166
Posts: 11470
Joined: July 11, 2006, 11:28 am
Location: Dove Creek, Co. elevation 6842
Poland

Re: hood issues

Post by ICEMAN6166 »

thats what i did
brought the back down to meet the cowl
1966 F250 4x4
1964 Rambler Ambassador 990
Rest in peace departed Slick family members
Cam Milam
Lesley Ferguson
Steve Lopes
John Sutton
Post Reply