So, if'n a guy was to want to swap out the manual trans behind a 300 I-6 in a '66 for a C6 Automatic, is there going to be issues with balance when swapping the OE flywheel for a flexplate?
I'm hoping it will be as simple as robbing the flexplate, blockplate, auto trans starter, kickdown linkage, etc from a newer donor and bolting it all up, but that Murphy guy follows me whereever I go
** Currently only contemplating this, still a long ways from pulling the trigger:)
And the (original??) 300 is only an interim engine, I have recently acquired a 1994 351W Roller engine, which will likely end up in the truck at a later date.....
James


