anybody in Texas have a FE engine in a pre '65 slick???

STOFFER · Post by **STOFFER** » October 1, 2007, 10:33 am

i am trying to find out what these headers I have for sale in the classifieds actually fit and if somebody has a FE engine in a pre '65 truck I'd like to see if they wil fit so i can adertise them properly

thanks

mikecarson · Post by **mikecarson** » October 1, 2007, 7:57 pm

Got a 390 in a 62

Uncle Skip · Post by **Uncle Skip** » October 1, 2007, 8:42 pm

Stoffer.
I have one in Nadine as you know. I had room for the original 427 cast iron shorty's so if your headers sweep back from the center of the motor you should be good to go.
The key is using the Trans-a-dapt crossmember which is right under the motor mounts. You can't use anything that goes straight down.
You coming back to Houston any time soon?
Spaghetti anyone?
U@ss

STOFFER · Post by **STOFFER** » October 3, 2007, 8:57 pm

Mike I drop by to check the fitment of the headers, lol

I thought they would fit a 65-66 but they won't clear

mikecarson · Post by **mikecarson** » October 3, 2007, 9:49 pm

Come on! The front clip is sitting loose, so it shouldn't be hard to tell.

Sent a PM

unitmatt · Post by **unitmatt** » October 4, 2007, 9:33 am

I just gonna go back with stock manifolds .If anybody in Houston,Tx
Wants to try these headers out let me know

anybody in Texas have a FE engine in a pre '65 slick???

anybody in Texas have a FE engine in a pre '65 slick???

Hey stoffer