A bit of recent engine history - I pulled the intake/exhaust and cleaned it up and reinstalled around the beginning of the year. New gaskets and bolts torqued to spec. Most recently I converted over to DSII.
So far I've been working my way through fuel, ignition, and air.
Fuel - pressure seems good. 5 psi before the fuel filter and 5 psi after.
Ignition - went through the wiring again to make sure all the DSII stuff was hooked up correctly. Swapped out the the module with an extra and it made no difference. Put a new coil in and wiring is set up for full 12v to coil. Pulled all plugs and gapped to DSII spec. Double checked all the sparkplug wires and looked for arcing, everything looked good. Found a crack in the dizzy cap - replaced and made no difference.
Air - ran without air filter (oil bath), made no difference lol.
I checked for vacuum leaks and the only place I could find one was the throttle shafts, which I already knew about. Vac advance was working correctly at the dizzy, and it pulled steady vac at the carb. I could find zero leaks by spraying around the base of the carb and around the intake.
I ended up pulling the carb and giving it a once over (I had recently rebuilt it). I installed throttle shaft bushings while it was out, which made no difference to the issue but did even out my idle.
Currently I'm running an autolite 1100 without SCV. Before that I was running a freshly rebuilt Carter YF which also experienced the issues.
I'm at a bit of a loss at this point. To me it seems like there must be a vac leak somewhere. I'm going to get more starting fluid and check again tomorrow. Maybe some more experienced members out there have some suggestions, I could use a "fresh set of eyes."
I'm beginning to think I should've just kept running load-o-matic!



