Carlite W-602 windshield. ( Free )

[FarmMotorSports]

Brand new only installed once.... No chips, nick's, cracks or scratches.
Has the dark tint strip across the top.
This is only suitable for chop top slicks!
This a factory Bo-Bo, it's a quarter inch to narrow and short, otherwise perfect...

If you want it, you pick it up just south of Lawrence Kansas... It should be available by November.

At least I hope to have a replacement installed by then.
May also deliver to SS , no guarantee on condition after a ride up in the bed of my slick.

[Kid]

how much of a chop. Not quite a 4 hr drive for me.

[FarmMotorSports]

I'll bring it to ya at SS... It's only a little short and narrow at the top... 1/4" each way at the top...
If you need it before then I'll work something out with you and meet you half way or better.

[Kid]

Maybe we can get the guys in KC and surrounding area to meet for lunch some Saturday and we will drive down and pick it up.

[FarmMotorSports]

OK, LMC windshield installed with the same Dennis Carpenter gasket. And the fit is only marginally better if any... All four corners still have a 1/8" to 1/4" gap.

My 1964 bus windshield and 61 gasket that had shrunk so much it had torn at the original seam and had a 2" gap in the center of the gasket, and was hard as nails but did NOT have gaps like this in the corners.

I compared the original Ford to the LMC and Carlite windshield.
The Ford was thickest at 1/4".
The LMC was only thinner by a 1/64 or less.
The Carlite the worst at 3/16" thick.

Shape of all the windshields is the same as far as I can tell by stacking them next to each other.
So I am at a lost. I may pop it back out in the spring and try the LMC gasket.