Re: Dana 60 5x5.5 Lug in 1/2 Ton Custom Cab

Hawkrod · Post by **Hawkrod** » February 23, 2008, 1:38 pm

Jarrod wrote:I like cake

You and me and Chuck Norris too (for those following the Chuck Norris thread on Fordification)
"Chuck Norris once ate a whole cake before his friends could tell him there was a stripper in it."
http://www.fordification.com/forum/view ... hp?t=28953

LOL Hawkrod
My favorite kind is "cheesecake":

crewzinforabrewzin · February 23, 2008, 10:17 pm

i know for a fact that my '66 f100 has a Dana60 and has posi. the ratio was either 3:70 or 3:73 (i cant remember which) i know this because recently i replaced the pinion seal. i do not know if it was stock in my slick or not. however following this thread i am curiose about it. i just went out to get the#'s off my rearend it was to dark to read them but my door tag has A9 as the axle code looked it up on the VIN decoder on this site and A9 is not listed.....anybody got any thoughts or info about this?

crewzinforabrewzin · February 23, 2008, 10:31 pm

just went back and had another look at the VIN decoder. A9 is listed in '65 and as 3:70 gear ratio according to the manufacturing dates my truck was made OCT.'65 so maybe that is my answer?

FORDBOYpete · Post by **FORDBOYpete** » February 24, 2008, 9:33 am

Now I'm confused

. . . . .

If your Dana60 is a Positraction it has to be out of a GM Product. FoMoCo never used Positraction in anything,
unless you are one of the folks who refer to all "traction assist devices" as being a "Posi".

FBp