
final ride height after the axle swap

overall view of swap. The axle was from '78 Malibu wagon. I should have taken a pic of IT. that thing is wasted.... hahaha!

upper link mounts (I put a gusset between the tabs), the pipe is welded to the frame, then a split-box gusset was added. I will probably close the box at a later date

The lower brackets from over axle

Spring perches, top is galv. pipe, channel and rusty water pipe. Bottom is original lower perch that was cut off axle due to conflicts. pipe has big gussets to bottom and sides of frame, inside.

Trust me, it LOOKS a LOT more dangerous than it actually was... The 2 Hi Lift Jacks alone would have been terrifying, but we had 2 rachet straps stabilizing it... one was attached to the 3000 pound generator, the other to a sway bar hung over a wall as an anchor. it was rock solid....

His 383 we put in during xmas break. Also the steering rack we had to relocate. That was a BIG project in itself. The engine balancer and rack wouldn't coexist in the location of existing eng mounts, so we moved rack about 8 inches forward with BIG bolts, cost $10 each, and chunks of pipe, and big gussets and plates. it looks really cool. I wish I had more pics...


We gotta get some brakes, a steering column, a radiator, and some hunk of crap to serve as a shifter and he'll be able to drive the thing around... it's getting close...
The whole axle project cost zero in parts, but $60 for gas for the damned generator that doesnt like to run. He doesnt have a 220 plug though. Sadly the truck is at his house. My garage has a nice clean, reliable 220 outlet, and a concrete floor, and a roof and a door.... man it would be nice to be able to work in there...... When we get the thing drivable maybe we start doing work at my place... trouble is ALL the REAL work is gonna have to go down/HAS already gone down at his place... what a pain!













