forged pistons

A place for discussion of off topic subjects. Pretty much anything goes - just keep it civil, please!

Moderators: Casey 65, Kid

Post Reply
User avatar
ethan_lanning
Posts: 134
Joined: March 5, 2007, 6:31 pm
Location: Saint Joseph missouri

forged pistons

Post by ethan_lanning »

has any one here ever used forged pistons? I was going to buy some a couple of day ago but when I called summit racing they told me that forged pistons are for racing motors and that the motor will knock when it is cold with forged pistons.they also said that Hypereutectic pistons will make more power.So now Im not sure what kind of pistons to buy. any suggestions?

ps.the pistons are for a 408 stroker that I would like to make 500hp out of.
Never poke another mans rust bubble.
http://www.supermotors.net/vehicles/reg ... 6959/57442
User avatar
dwbr
Posts: 474
Joined: July 16, 2007, 4:23 pm
Location: Pasadena TX

Post by dwbr »

im using Keith Black Hypereutectic pistons in my 514 stroker, was informed to make sure you use the ring gap specs that keith black gives is alot more than usual, but i dont even have 100 miles on mine yet after installing,so far so good,
________
starcraft II replays
Last edited by dwbr on February 7, 2011, 12:11 am, edited 1 time in total.
User avatar
lefty
Posts: 152
Joined: April 25, 2008, 1:08 pm
Location: Central Northeast Texas!!

Post by lefty »

I have ran the KB Hyper pistons in a race motor for three years, and it has NO blow by, the compression is still where it was when it was first built, and its never been freshened!
'61 Uni SWB BBW Custom Cab 302 T-5 w/ Power brakes
It ain't pretty either!
Image
User avatar
Bills 66
Posts: 135
Joined: July 17, 2006, 12:58 pm

Post by Bills 66 »

Forged pistons generally need more piston to cylinder wall clearence than cast or hyper pistons. This can cause piston slap until they are warmed up and expand. I ran forged pistons in a 440 and could never hear the pistons slapping over the loud exhaust and lopey solid lifter cam. But this was a 12.5 compression engine when you could buy sunoco 260. I only ran it about 2 months and got drafted (1969) and was forced to sell it. That GTX would sure set you back in the seat.
Bill
User avatar
DocDave
Posts: 206
Joined: July 17, 2006, 4:00 pm
Location: Fort Providence Northwest Territories

Post by DocDave »

48 International had forged pistons (I think, might have just been wear). Noisy when she first started but quieted up after about 2 minutes. Never had a problem with the old beast, but I wasnt winding it up to any great degree either.
Dave
From a guy without his Ford that he left on a rock in the North Atlantic.
blackagatha
Posts: 2582
Joined: March 10, 2007, 12:49 am
Location: Arizona

Post by blackagatha »

that is strange! I had no idea... I assumed a forged piston would behave just like any other, but less likely to break under extreme pressures?
'63 with 390 & lots of juice. But never enough. Always want more.
ImageImageImage
Post Reply