94 Ford Mustang - T-Bird tranny interchange?

A place for discussion of off topic subjects. Pretty much anything goes - just keep it civil, please!

Moderators: Casey 65, Kid

Post Reply
User avatar
Greg D
Posts: 10113
Joined: September 13, 2006, 4:39 pm
Location: Podunk Iowa
United States of America

94 Ford Mustang - T-Bird tranny interchange?

Post by Greg D »

I am planning a T-5 for my 62.
There 2 ways to do this, I am using John Mummerts adaptor with a 94-95 Mustang T-5 rather than the bellhousing modification with a 85-93 T-5 (the V6 trannys are strong enough for a 292 if they are 94-95). The 94-95 Mustang tranny has a longer input shaft and works with the adaptor. A local yard has a 5 speed from a 94 T-Bird Supercoupe. Does anyone have access to parts interchange info from a 94 Bird to a 94 Stang to tell me if this tranny will work? The $200 with a 30 day warranty they are asking is kinda tough to beat.
1964 F 100 - I am going to do "something" with it.......

viewtopic.php?f=32&t=15942

1987 Mustang LX Convertible, 2.3 Auto - cruiser.
1994 F 150 XLT 2WD


~ Yes - I adopted another cat..............

Cam L Milan,
You'll be missed my friend.
fmartin_gila
Posts: 1021
Joined: April 21, 2007, 9:58 am
Location: Mandurriao, Iloilo City, Philippines

Post by fmartin_gila »

Check the 1352-___ number. If it is220,236,or 238, it will work. I used a 236 at first, then switched to a 238 cause the first one was not shifting right. The 238 has a 8 tooth speedo drive gear and the 220 and 236 have a 7 tooth speedo drive gear. I used John Mummert's setup when I installed the T5 in my 62 with a 223. It should be the same setup as you are contemplating. I did have to cut off about 1/4 inch of the input shaft in order to maintain some end play in the crankshaft. I just used a 4 in cut-off wheel and kept rotating the input shaft by hand until it got down to the recessed part in the end of the shaft. I did have to use a lot shorter driveshaft. I made a short shift lever adapter to bolt to the lower shift lever to 'Z' the upper portion of the shifter about 3 inched to the front to clear the seat so it could be shifted into the 2, 4 and R positions.
Fred
Post Reply