Small engine question

A place for discussion of off topic subjects. Pretty much anything goes - just keep it civil, please!

Moderators: Casey 65, Kid

Post Reply
willy3486
Posts: 817
Joined: July 11, 2006, 10:31 am
Location: Smithville TN

Small engine question

Post by willy3486 »

I have question on a Briggs and stratton engine. It is a 6.5hp ohv engine on my wood chipper. I tried to start it today and ran into problems. I tried to pull the string and it would hang up. I cleaned it out and I noticed that gas would pour out of the muffler. I also noticed it would leak by a gasket that was just below the muffler. I did not try to start it after that. As far as the engine goes it has very little use ,maybe 10 hours at the most. But it is a few years old and it has been stored in the dry when not in use. I did not see any cracks and the last time I used it the chipper did not act up. It has not been started in a couple of years so I am wondering is a seal or gasket has dry rotted. Any ideas? It looks a lot like this one at the link below.


http://www.commercialpower.com/display/ ... ocID=76962
User avatar
66fordtrucknut
Posts: 1289
Joined: July 11, 2006, 11:48 pm
Location: Eastern Shore - MD

Post by 66fordtrucknut »

Try here Willy, these guys are pretty good. I had a problem with my splitter, mine wasn't getting gas. Good luck.
Charlie
http://www.hobbytalk.com/bbs1/index.php?
62' SWB uni 223
66' F-100 Short/wide 352
78' F-350 dually dumpbed 400
12' F-150 5.0 3:73 LS
User avatar
uglyblue66
Posts: 49
Joined: October 17, 2006, 9:57 am
Location: North Carolina

Post by uglyblue66 »

Your float may be bad in the carburator.Or needle stuck open due to this sorry gas that gels up in nothing flat.
The over head valve engine would be able to gravity feed fuel thru the carb,thru the open intake valve and would be able to drip out the exhaust once the cylinder was full.You will need to do some carb work,then remove the spark plug and hopefully get that cylinder dried up,then change the oil as it probably has gas in it now.
Our cow kicked the bucket,so we dont need anymore Bull.:>)
willy3486
Posts: 817
Joined: July 11, 2006, 10:31 am
Location: Smithville TN

Post by willy3486 »

Thanks guys. I will check that out Mack. That makes a lot od sense with it being gummed up. It has sat about 2 years I think. Once I got it started it would always run good. I think I will try to let it drain from the piston this week and let it set until the week of the 4th. I may dig into it then.
User avatar
Slick Fan
Posts: 4085
Joined: November 4, 2006, 5:09 pm
Location: UTAH...snow blows!

Post by Slick Fan »

You may want to change the oil too, while you're emptying the cylinder. If the cylinder gets full of gas, it's bound to seep past the rings & fill the crankcase with gas. It happens on motorcycles very often, when a carb needle sticks open.
My "Slickitis" affliction began here...
Image


66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!
Post Reply