Thunderboy

A place for discussion of off topic subjects. Pretty much anything goes - just keep it civil, please!

Moderators: Casey 65, Kid

Post Reply
User avatar
Fanatic
Posts: 1568
Joined: July 14, 2006, 11:39 pm
Location: Leesport, PA

Thunderboy

Post by Fanatic »

I can't seem to reply to your message

So here ya go::::::

I put some more pics in my album.

http://fordtruk.com/forums/album.php?user_id=40

My setup is a EEC-V OBD 2. I used this because I picked up a 1996 F 150 that was rolled with 16K miles on it. Got 4R70W trans

I still need to clean up some of the wiring to finish things up but life keeps getting in the way!

Everything is under the hood. I made that aluminum box under the heat sink to hold the computer (weathertight) Updated electrical system with the underhood fuse box from another 90s pick-up. I no longer have any fuses at the headlight switch. Custom made intake tube since trucks use a dual throat throttle body. Lots of hours under the hood with wiring diagrams to run everything. I also installed a full electronic 96 Thunderbird instrument cluster to take advantage of all of the capabilities of this set up.

If I did it again............
.I'd use the EEC-IV system. I had to run from the 104 pin computer for all of the wiring. the EEC-IV uses a 60 pin computer.
I'd use a car intake so that I could find other upgrades if I chose.Actually the truck set up is better but there is little performance upgrades for it.
If I was to stay stock, which I am, I'd choose the truck intake
I'd make or find a fuel tank that would utilize a stock type fuel pump (in tank) just to simplify the fuel system.

I really don't have any regrets on how I did the truck but it was a HUGE learning curve with the Fuel Injection/Computer controls. I have done lots of toying in the past but always with carbureted engines. I still need to get to a shop that can get into the system and make everything correct or at least check it. Everything seems fine but I'd like to know for sure. I wired in the plug for a scan tool and don't have any bad codes coming up.

I'll be glad to answer any questions that I can or show you what I did!

I have abit of pretty good write ups for doing the EEC-IV system.


Tim direct e-mail fnatic1543@aol.com
INEPTOCRACY: (in-ep'-toc-ra-cy) : a system of government where the least capable to lead are elected by the least capable of producing, and where the members of society least likely to sustain themselves or succeed are rewarded with goods and services paid for by the confiscated wealth of a diminishing number of producers.
Thunderboy
Posts: 335
Joined: August 26, 2008, 2:24 pm
Location: Sacramento, California

Post by Thunderboy »

WOW! Thanks for the info, Tim. I will email you direct later.

Drew
Drew


66 F250 Frame swap, EFI 408W, ZF 5-speed swap (still!) in progress
63 Falcon Futura EFI 331W, T5, but not much progress... Slicks First!!!
Post Reply