Dust Shield on 4 Speed Flywheel housing availability

teamhaney · Post by **teamhaney** » November 27, 2006, 12:10 pm

Hi, Had to remove my NP tranny to get at a busted throwout bearing. While I have it apart I'd like to replace the dust shield for the release lever that goes through the flywheel housing. Called NAPA, it's doubtful they have one. Theirs fits 80-83 Chevy. Anybody replaced one of these? Where did you find one?

jakdad · Post by **jakdad** » November 27, 2006, 12:37 pm

Prolly Dennis Carpenter.

ICEMAN6166 · Post by **ICEMAN6166** » November 27, 2006, 12:39 pm

team, you might try here
http://www.drivetrain.com/transillchrydodge_np435.html

dont let the dodge word in the link bother you, they used the 435 too

mikecarson · Post by **mikecarson** » November 27, 2006, 6:49 pm

Think I saw them in the LMC catalog, too.

teamhaney · Post by **teamhaney** » December 6, 2006, 12:42 pm

I found the dust boot. I think if you have a NP 434 they interchange up to 79. I went to a ford dealer and asked for a boot for a 75. The one that came back had part number C5... They guy was surprised when I said that was a 1965 part number. Anyway now I gotta figure out how to get the spring clip in.

Dust Shield on 4 Speed Flywheel housing availability

Dust Shield on 4 Speed Flywheel housing availability

Seal Found