Page 1 of 1
Leaf springs
Posted: June 21, 2010, 10:26 pm
by rctcomp
The leaf springs on my 65 1/2 ton are wonky. is there a way to fix this without paying LMC $800? Can I take some leafs from my 64 3/4 ton parts truck and replace or add them to my 65? They're about the same width.

Posted: June 21, 2010, 10:34 pm
by ICEMAN6166
yes
the only difference between the f100/250 is the amount of springs in the stack. some might be a bit thicker too but the width is the important part.
Posted: June 22, 2010, 7:16 am
by Brian Taylor
I have to ask:
What does "wonky" mean??
Posted: June 22, 2010, 11:14 am
by Obsa
Posted: June 22, 2010, 11:25 am
by jakdad
I think your best bet is to take them to a spring company and have them rearched. They will also retemper the springs. You will probably have to go to Salt Lake City to find a spring company. Good luck.
Posted: June 22, 2010, 1:00 pm
by ICEMAN6166
last time i had work done at the spring shop re-arch was only guaranteed if a new mainspring (the one with the bushings) was used.
Posted: June 22, 2010, 11:31 pm
by rctcomp
Whats the advantage to getting the re-arch vs using leafs from another spring? I've never torn down a stack of springs before, maybe I should just bite the bullet and 'spring' for a new set.
I substitute wonky in place of f'd-up when the kids are around.
.
Posted: June 24, 2010, 10:25 pm
by jmf66
I've had springs rearched before and it only last for a while. If they're wompy.. you need new springs. Heck, they're over 45 years old! A local spring shop may be you're best bet. You might also check Kansas City Spring.. For my falcon, it was cheaper to order from them. Their website is generalspringkc.com