Big truck lower valance

DIESEL DADDY · Post by **DIESEL DADDY** » March 5, 2013, 11:33 am

Looking for pictures of a slick with the big truck lower valance. I remember seeing atleast one of a blue slick with that valance but I can't find it now any ideas where to look ? tks

F7BIGJOB · Post by **F7BIGJOB** » March 5, 2013, 12:00 pm

How's this??

HiBoy63 · Post by **HiBoy63** » March 5, 2013, 1:35 pm

Just the pan by itself still attached to core support and grille

A few mine that have the lower big or 4wd gravel pan.
I have more but it seems like this has gone on to long.

DIESEL DADDY · Post by **DIESEL DADDY** » March 5, 2013, 2:31 pm

tks for both replys I didn't realise that the 4x4 used that valance too I want to use that on my uni without a bumper like a rolled pan

HiBoy63 · Post by **HiBoy63** » March 5, 2013, 2:45 pm

DIESEL DADDY wrote:tks for both replys I didn't realise that the 4x4 used that valance too I want to use that on my uni without a bumper like a rolled pan

No problem should bolt right in.

Check Greg Ds traditional build of 64 F250 over in the projects forums. Click on the 12 page link takes you to what he is doing with the same panel.

F7BIGJOB · Post by **F7BIGJOB** » March 5, 2013, 3:08 pm

Vic, that green '62 is sweet!!

frank66 · Post by **frank66** » March 8, 2013, 9:40 am

Found this on craigslist. Think this was built from scratch? Or did he start with the big truck valance?

http://hartford.craigslist.org/cto/3629756494.html

Post by **Greg D** » March 8, 2013, 4:23 pm

Frank66, Looks to me like he modded one of the rear roll pans.
It looks to "straight" to be the stock piece.

Unmodified (yet) Big Slick/4x4 roll pan on my 64 2wd F 100;

A shot a little more form the side;

Gritsngumbo · Post by **Gritsngumbo** » March 8, 2013, 4:44 pm

I was thinking it might be one of the LMC bumpers with the driving light insert holes, molded into the truck.

http://www.lmctruck.com/icatalog/fb/full.aspx?Page=2

But probably not. Greg's probably right.

Maybe something like this (bottom of the page)

http://www.lmctruck.com/icatalog/fb/full.aspx?Page=57

Post by **Greg D** » March 8, 2013, 5:29 pm

BTW guys,
you will have to cut about 8" off the frame.
I get pics showing from underneath if you need them.
I can take measurements of the trim off too - if I can find them.
Also notice that if I go straight when I fill the valance the shackles will still show.
I am thinking of a drop there (blended of course) and a frenched plate mount.
Another thought I have is a modified & tucked 61-66 Chevy truck bumper in front of the pan.

Big truck lower valance

Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance

Re: Big truck lower valance