Page 1 of 1

Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 22, 2015, 6:48 pm
by chris401
I read the correct 2 groove alternator pulleys were cast iron. Would this pulley be correct for my 352 F250?
Image

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 12:21 pm
by chris401
My pickup was plain dual belt alternator, no other options. Anyone have a photo of the correct pulley?

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 2:13 pm
by ICEMAN6166
Chris
i got a lot of actual pics, i will keep looking but this exploded diagram does show the 2 belt pulley
Image

only cast iron pulleys i can recall are on the FT that came out of a 65 or 66 bus, not sure if the alt had one or not
Image

looked thru 56 pages of pics and still i have not located the 2 pulley alt , i will look some more.

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 2:24 pm
by chris401
Thanks. I'll try to relocate that post. Poster said stamped steel pulleys were not correct. Maybe I miss read the truck they were talking about. From what a couple older techs have said on my engine compartment have an old U-Haul rental truck. Apparently the same set up a governed 1 ton would have.

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 2:37 pm
by ICEMAN6166
the one in your pic looks like machined steel which is an upgrade over stamped steel

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 5:06 pm
by chris401
I'll run with that. Wished I kept the round back and pulley that was on it when I first bought it. Never paid attention to what pulley was on it, if still original.
Thanks

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: October 26, 2015, 7:56 pm
by chris401
10344 in your post is what a stamped steel would look like if they were going for accuracy.

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: February 19, 2016, 7:43 pm
by chris401
I found this alternator on a 67 330 MD. The stamping on the pulley is C5TF-10A352-K2. If these trucks had cast pulleys this is probably it. Transferring the pulley to mine till I rebuild the correct round back Autolite on the left.

Image
Image
Image
Image

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: February 28, 2016, 9:33 pm
by LM14
http://www.mustangtek.com/pulley/Pulley.html

Great pulley and casting number info.

Re: Is This The Correct Alternator Pulley For A 1965 F250?

Posted: February 28, 2016, 10:28 pm
by chris401
LM14 wrote:http://www.mustangtek.com/pulley/Pulley.html

Great pulley and casting number info.
I didn't see my dual belt application on there.