Page 1 of 1
Garbz
Posted: September 11, 2006, 12:12 pm
by 64 f100
Sent you an E-mail with the address I have for you, but came back saying not deliverable. Wanted you to know, that when I took the heads of the engine with good crank things didn't look good. Took out one piston, checked ring end gap. Never saw a ring with 80 thousandths end gap before. Ruined the cylinders so it has to be overbored. Valve guides are shot also. Good thing I got the good crank, cause that's all I got with this engine. Glad I din't just put it in, I would have been slightly disturbed.
Rich
Posted: September 11, 2006, 12:33 pm
by Garbz
d.garber@bognetinc.com
that ones still good for a week or too
garbz-@hotmail.com is the alternate one
Bummer.... 80 on the rings

.. what was the taper? whith that much it should be huge. Might not clan up at 60 over.
Garbz
Posted: September 11, 2006, 1:27 pm
by ELpolacko
Posted: September 11, 2006, 8:22 pm
by 64 f100
Whoever the dumb bass was ran it for to long. Even the top ring had a ridge on it. Taper was 5 thousandths at the top. Your right, it may not clean up at 60 over, although it would probably work OK, unless it has a bad wear pattern. At a guess, I'm thinking the oil wasn't changed nearly often enough. Valve guide slop was really bad to. Leaves me high and dry, in a couple of respects. More money out, and still have to do another overhaul. Y blocks are a pain, and expensive to work on. Even cutting all the corners I can, I will be lucky if I get by at 800 each. Having to bore one with pistons and rings it's about 3 bills add another bill for gaskets, and another 100 for bearings. Without the the heads it's 500. I'm getting the ones I spent so much money on before redone, for about 300, and those already have hardened seats. Hopefully, I've got a decent set of stock heads, that don't need anything but a touchup. Otherwise, I've bought one new set of lifters, two new rocker assemblies ( big bucks there), and I'm thinking on a bigger cam for the green truck to go with the four barrel and big valve heads. This is one nasty can of worms, I've gotten myself into. Forgot to add, I need a new clutch in the green truck also.
Rich