Page 1 of 1

bedside seams

Posted: June 1, 2008, 6:16 pm
by 62galxe
just curious what is used before the seam sealer is applied.thought about por 15.what works for yall.

Posted: June 4, 2008, 5:20 am
by 62galxe
no special prep tips for the seams?

Posted: June 4, 2008, 6:49 am
by GDG
Seam sealer should go over the primer.
Doug

Posted: June 4, 2008, 11:39 am
by Slick Fan
GDG wrote:Seam sealer should go over the primer.
Doug
Although I have yet to do this myself, I agree. That's what I've noticed most other folks have done.

Posted: June 4, 2008, 3:46 pm
by Greg D
My personal opinion is "weld em up & fill em". 8)

Re: bedside seams

Posted: June 4, 2008, 4:18 pm
by jwh f-100
62galxe wrote:just curious what is used before the seam sealer is applied.thought about por 15.what works for yall.
Yes something like that should be used, then primer, then seam sealer, and possibly prime again.

I think when I do my bed I am going to try using a brush along with regulated compressed air to try to get the rust converter/prohibiter to penetrate deep into the seem. To the point it "bleeds" out the other side.

Posted: June 4, 2008, 5:40 pm
by 62galxe
thanks. now to get busy on the truck. :roll:

Posted: June 4, 2008, 7:56 pm
by helicorbin
Pro-Seal (aircraft sealant) you can shape it nice with soapy water and its paintable ! I use the stuff on rotors that spin just under mach at the tip under 122 g's at 110% power, and I have used it to seal fuel cells. In other works you wont have to mess with it for a while. ha-ha

I think you can get a tube or qt of it around George Bush Interc. Arpt.