Page 1 of 1

I need some parts

Posted: July 30, 2008, 6:28 pm
by Uncle Skip
Finally, a use for one of those old worn out wiring harnesses.
I need the two inside and outside wiring plugs that go thru the firewall, and an extra ignition switch if someone has one laying around.
Really, that's all I need.
I'm either going to be a Slick Wiring Genius, or a complete and total idiot.
Believe it or not, I actually went thru and identified each wire and what it goes to, even the turn signal cam.
My custom wiring harness went south and I can't seem to fix the problem (I know what the problem is, I just can't fix it) so I'm going to build my own, I think using the original switches.
Think one of you can bail me out?
Anyway, if I'm a success, I'll share what I know...........
if not, well....................................................
Bwahahahahaaaaaaaaaaaaa
Tio Skip :twisted:

Posted: July 30, 2008, 10:49 pm
by Jarrod
What happened to your custom harness. Wasn't it built by a guy here? Is he helping you trace the issues?

Re: I need some parts

Posted: July 31, 2008, 8:53 am
by jwh f-100
Uncle Skip wrote: I'm going to build my own, I think using the original switches.
Doing the same here.
I'm making a diagram in my head and have supplies on the way. (Butt connectors not included :) )
Good luck and enjoy.

Sorry can't help with the connectors. They will not be used with my new harness but I'd like to save them.

Posted: August 1, 2008, 1:14 pm
by racerx1699
I have the connectors, but no switch. You can have them, I'm going with a Painless wirering harness in mine when I get that far. PM me with an address and I'll get them sent.

Posted: August 1, 2008, 6:56 pm
by jkimbrel65
Got a painless one in the uni and an ezwire in a duster.Will never use factory harnesses again :D

Posted: August 2, 2008, 10:35 pm
by johnny
:iagree: ive got ez wiring in both my 55's did them both myself took about10-12 hours

john