Wiper bracket bolts
Wiper bracket bolts
Anyone know what the bolts that go into the plenum/firewall that hold the wiper assembly? I'm assuming 5/16-24 thread but I don't have a tap to check it and my usual bolt store only has 18 thread.
Re: Wiper bracket bolts
I'll check in the morning to verify, but I believe the '64 and older Ford/ Mercury applications, regardless of car or truck, were indeed all fine thread. Stateside, anyway!
Paul
Paul
The Ford Orphanage
Life's too short for boring vehicles!
My quest to develop a universal solvent is held up by the lack of a storage container.
Paul
Life's too short for boring vehicles!
My quest to develop a universal solvent is held up by the lack of a storage container.
Paul
- unibody madness
- Posts: 2147
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969

Re: Wiper bracket bolts
61s are nf as well
Turk build thread at:
http://slick60s.com/viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
http://slick60s.com/viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
Re: Wiper bracket bolts
I think 18 AND 24 tpi are both still NF???? I have a 5/16 NC tap, but there's no way that's going to fit. 
I read in a few places ford used the 24tpi?! I'm not entirely sure, but I know someone on the forum will.
The 18tpi bolts I do have don't really want to wind in.
Appreciate anything you boys can dig up!
I read in a few places ford used the 24tpi?! I'm not entirely sure, but I know someone on the forum will.
The 18tpi bolts I do have don't really want to wind in.
Appreciate anything you boys can dig up!
Re: Wiper bracket bolts
Hmmmmm well that really screws my theory!!
Thanks James, looks like I need the fine tap then!
Thanks James, looks like I need the fine tap then!



