so got into cleaning the cylinders out from the head gasket blow cleaned 6 of them out and the tops of the pistons off then when #6 was down in the hole i see this fine thing, appears that coolant was in the hole for the whole winter and eroded the cylinder wall.
pretty sure the decriptive word is (censored)


hey, cylinder bores are supposed to be smooth as a babys butt, this one is more like a teenagers acne pocked face.
not sure if it can be honed out, pistons are stamped .040 meaning engine has been bored.i checked it is indeed 3.790
i special ordered a full gasket set, so im already out that $
only choice at this point is to try to clean it up best as possible and put it back together and it will run because it was running the other day until the rings start to get eaten and it begins to burn oil and loose compression.
probably be ok for local use for a while but definitely not a long trip of thousands of miles
going to need to replace it im sure
not much for y blocks on cl around here
all for a $5 thermostat
AAARGH!


