Torque Converter Question.....

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

Post Reply
User avatar
Mr. Jones
Posts: 741
Joined: May 7, 2012, 10:43 am
Location: Emporia,Ks.
United States of America

Torque Converter Question.....

Post by Mr. Jones »

Installed my COM back in 2001,rebuilt then..decided to get it back on the road last Sunday....but I don't remember if I filled the torque converter...I was told not to start it dry...True or False.....I ask this question on FB,one guy said add about eight qts.then top it off when running,don't know if he's a member here or not....need some more input from real Slickster's
Thanks
Dan
___________________________________
"DW JONES TRUCKING"
WHISKEY HAULED,LIES TOLD AND WIDOWS WOO'ED......
"By appointment only"
64 f100
Posts: 2754
Joined: July 18, 2006, 7:23 am
Location: Carmi, Illinois, 62821

Re: Torque Converter Question.....

Post by 64 f100 »

You know to use type F transmission fluid in the C/M. I just checked the Ford manual for our trucks and it only said the transmission held a little over 10 quarts. I cannot say that for sure, as I really did not understand what transmission the spec was for. As to the question about filling the converter, it can't hurt to put some in it. At least I've never heard of someone blowing up a tranny that way.

Rich
Day 2
Posts: 137
Joined: January 24, 2017, 9:52 am

Re: Torque Converter Question.....

Post by Day 2 »

If you don't get the answer your looking for here, try this;
http://www.network54.com/Forum/260730
longcabjohn
Posts: 356
Joined: January 21, 2012, 1:08 pm
Location: waverly, Tn
United States of America

Re: Torque Converter Question.....

Post by longcabjohn »

Since it is together, pull coil wire and crank and it will turn pump and put fluid into converter. When first starting I would jack up rear and put in drive. Be sure to use brake before
putting into park.



Johnny
If restoring a ford was easy, chevy guys could do it.
64 f100
Posts: 2754
Joined: July 18, 2006, 7:23 am
Location: Carmi, Illinois, 62821

Re: Torque Converter Question.....

Post by 64 f100 »

I did some reading and the book says to put in 5 quarts and then start the motor and bring it to 1200 rpm until warm , then let idle and check fluid with the engine running then ad if needed . it also said to run it thru the gears before checking. Said nothing about filling converter.
bruceandersson
Posts: 906
Joined: August 12, 2009, 9:44 am
Location: Ohio

Re: Torque Converter Question.....

Post by bruceandersson »

I would have the back end up on jack stands to avoid as much resistance as reasonable. I'd then pull the plugs and crank to allow the pump to circulate what it can. Then start on the stands and run through the gears, checking fluid as necessary.
User avatar
Mr. Jones
Posts: 741
Joined: May 7, 2012, 10:43 am
Location: Emporia,Ks.
United States of America

Re: Torque Converter Question.....

Post by Mr. Jones »

OK,looks like I can proceed.....fill 1st.crank it over w/ no spark then start......Thanks for the replys .....
Dan
___________________________________
"DW JONES TRUCKING"
WHISKEY HAULED,LIES TOLD AND WIDOWS WOO'ED......
"By appointment only"
Post Reply