Bit size for Ford seat belt fasteners...

A place for discussion of off topic subjects. Pretty much anything goes - just keep it civil, please!

Moderators: Casey 65, Kid

Post Reply
User avatar
The Big M
Posts: 1360
Joined: August 9, 2006, 3:03 pm
Location: Rocky View County, AB
Canada

Bit size for Ford seat belt fasteners...

Post by The Big M »

Does anyone know what size of Torx bit I need to unbolt the seatbelts in my '87 Grand Marquis? I had one once, but I don't remember what size it was. I'm assuming that most or all Fords of the same vintage use similar fasteners.
Phil
Posts: 2125
Joined: June 1, 2007, 9:37 pm
Location: toledo

Post by Phil »

I am 75% sure its size 50
Someday I'll get another slick :(
Image
User avatar
DocDave
Posts: 206
Joined: July 17, 2006, 4:00 pm
Location: Fort Providence Northwest Territories

Post by DocDave »

I'm 100% sure it's a T-50. If it's from a salt useing area you may go through a few with an impact gun. If you can use some penetrating oil from underneath before you try it helps alot. Buy a good one, The cheap ones are too hard of a temper and snap easily. The 70's were a T-45 and the newer ones are a T-55. The manufacturers just love to make us buy new tools every couple of years. Seriously what difference is there in the holding power of these bolts?
Dave
From a guy without his Ford that he left on a rock in the North Atlantic.
User avatar
The Big M
Posts: 1360
Joined: August 9, 2006, 3:03 pm
Location: Rocky View County, AB
Canada

Post by The Big M »

It is indeed size 50. I picked up a $30 set of six from Canadian Tire, guaranteed for life. And now I get to test that guarantee, because I snapped the bit on the one bolt that I didn't spray with penetrating oil. And I was using a 3/8-drive ratchet, not an impact.

So I see what you mean about the hard temper, Dave... :lol:
Z-MAN
Posts: 213
Joined: May 21, 2007, 9:28 pm
Location: Houston

Post by Z-MAN »

Yup T-50
User avatar
Slick Fan
Posts: 4085
Joined: November 4, 2006, 5:09 pm
Location: UTAH...snow blows!

Post by Slick Fan »

I've broken two Sears T50's off on my Crown Vic's bolts...the remaining portion of the last one is still sitting in the bolt head. :lol:
I bought a Snap-on torx for 23 stinkin' dollars...have yet to try it. :?
My "Slickitis" affliction began here...
Image


66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!
User avatar
DocDave
Posts: 206
Joined: July 17, 2006, 4:00 pm
Location: Fort Providence Northwest Territories

Post by DocDave »

Ya but I think I've broke 2 Snap-ons in thirty years but anytime I buy a different brand It only lasts about a year before I run into a tough one so I buy another Snap-on.

You want to try and get a back seat belt out of a twenty year old GM after it's been sitting for 19 of them in a scrap yard :lol: in salty Ontario. I had to sometimes cut the seat frame or the whole floor section came up with a couple.

Dave
From a guy without his Ford that he left on a rock in the North Atlantic.
Post Reply