So i'm just about done collecting parts for my CV and V8 swap. Just waiting on a few parts to finish up the motor.
The short of it, i'm swapping in a 289 small block mated to a C4.
My question is, how low with the CV go on airbags? I plan to put the truck on air once the swap is done, but i'm curious if it will lay frame without raising the CV K-frame or Z-ing the frame up front. Anyone have any experience or photos of their slick with a CV swap on air?
Crown Vic Swap Height Question
- texastoast_
- Posts: 6
- Joined: May 25, 2018, 9:47 am
- Location: Dallas, TX

Crown Vic Swap Height Question
'63 F100 Longbed Flareside
- texastoast_
- Posts: 6
- Joined: May 25, 2018, 9:47 am
- Location: Dallas, TX

- FarmMotorSports
- Posts: 451
- Joined: November 13, 2010, 6:55 pm
- Location: KS, Lawrence

Re: Crown Vic Swap Height Question
While I'm sure there are members who have done the cv on the low down... most don't visit daily or even weekly... the facebook page may get fast results, if you're in a hurry.
61 F250 Unibody
5.9 Ford Diesel / Allison auto
& 4WD
5.9 Ford Diesel / Allison auto
& 4WD
- texastoast_
- Posts: 6
- Joined: May 25, 2018, 9:47 am
- Location: Dallas, TX

Re: Crown Vic Swap Height Question
Thanks for the info. I did post this a little while ago to the CV swap FB page, so hopefully get lucky there.
'63 F100 Longbed Flareside
