Crown Vic Swap Height Question

The place to talk Slicks. All we ask is that discussion has something to do with slicks...

Moderators: Casey 65, Kid

Post Reply
User avatar
texastoast_
Posts: 6
Joined: May 25, 2018, 9:47 am
Location: Dallas, TX
United States of America

Crown Vic Swap Height Question

Post by texastoast_ »

So i'm just about done collecting parts for my CV and V8 swap. Just waiting on a few parts to finish up the motor.
The short of it, i'm swapping in a 289 small block mated to a C4.

My question is, how low with the CV go on airbags? I plan to put the truck on air once the swap is done, but i'm curious if it will lay frame without raising the CV K-frame or Z-ing the frame up front. Anyone have any experience or photos of their slick with a CV swap on air?
'63 F100 Longbed Flareside
User avatar
texastoast_
Posts: 6
Joined: May 25, 2018, 9:47 am
Location: Dallas, TX
United States of America

Re: Crown Vic Swap Height Question

Post by texastoast_ »

Anybody?
'63 F100 Longbed Flareside
User avatar
FarmMotorSports
Posts: 451
Joined: November 13, 2010, 6:55 pm
Location: KS, Lawrence
United States of America

Re: Crown Vic Swap Height Question

Post by FarmMotorSports »

While I'm sure there are members who have done the cv on the low down... most don't visit daily or even weekly... the facebook page may get fast results, if you're in a hurry.
61 F250 Unibody
5.9 Ford Diesel / Allison auto
& 4WD
User avatar
texastoast_
Posts: 6
Joined: May 25, 2018, 9:47 am
Location: Dallas, TX
United States of America

Re: Crown Vic Swap Height Question

Post by texastoast_ »

Thanks for the info. I did post this a little while ago to the CV swap FB page, so hopefully get lucky there.
'63 F100 Longbed Flareside
Post Reply