Shop Compressor drain
Shop Compressor drain
What kind of set up do you folks have for your compressor drain? The way mine is now, I end up with water all over the shop floor. Thought I might run my drain through the wall to some kind of sump in the ground. Don't know how to go about it. Open to suggestions..................
Thanks
Thanks
Jim
-
ICEMAN6166
- Posts: 11470
- Joined: July 11, 2006, 11:28 am
- Location: Dove Creek, Co. elevation 6842

I haven't tried this yet, but I read a good idea on another site a while back of putting a ball valve on the bottom, with a length of hose on the other end.

If you don't have a floor drain, you could probably put the other end of the hose in a bucket or something...maybe. Still has the potential to make a mess, I guess.

If you don't have a floor drain, you could probably put the other end of the hose in a bucket or something...maybe. Still has the potential to make a mess, I guess.
My "Slickitis" affliction began here...

66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!

66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!
Thanks, I know a bucket wont work. I would end up with water all in the rafters and other stuff I have overhead
. I have galvanized pipe comming out of it now with a valve. I may have to continue it through the wall. I'm not sure what to do once it's outside due to noise and blowing water/oil all over the back yard.
Jim
Yeah, I guess that could pose a problem.jakdad wrote:I'm not sure what to do once it's outside due to noise and blowing water/oil all over the back yard.
My "Slickitis" affliction began here...

66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!

66 F100 CC/65 F100 CC/66 F250 CC
If it starts to rain, they'll tax the splash.
If you want to fish, they'll tax the bass.
If you plant a yard, they'll tax the grass.
If you don't play nice, they'll fine your *$#!
-
ghostflamed66
- Posts: 98
- Joined: April 3, 2006, 10:57 pm
- Location: centerville,Ia.

Sounds like a good idea. What size hole? 2X2 X 2feet deep? Use about 12" of rock in the bottom? That should muffle the noise. Maybe 30" deep.
Here is the offending machine.
http://fordtruk.com/forums/album_showpa ... user_id=77
Here is the offending machine.
http://fordtruk.com/forums/album_showpa ... user_id=77
Jim
At work we run it outside (points stright out). It has a ball valve on it and normally we just crack it open to drain just the water out then shut it when it starts blowing air and do not drain all of the air. When it is very humid I very slightly open it. It very slowly drains on its own. It is opened so slightly that it creates a "fog" out the drain but keeps the tank dry. Every so often it gets opened fully also. When the drain was not outdoors it was a pain in the neck.I'm not sure what to do once it's outside due to noise and blowing water/oil all over the back yard.
The air going into the tank is probably over heated due to being a two stage pump. Maybe other pumps have a cooling cycle. Don't know how to go about doing that.36truck wrote:I can see why you have so much water. It pumps in all the hot air right into the tank. There is no cooling before it goes into the tank.
Make the hole big enough to hold all the water x3-5 times in order to let it soak into the ground.
Jim
when i was akid my dad had a hotwater tank that was made intot a compressor. on the end of the tank as it layed onits side. he had a cock vavle like a radiator. and a piece of surgical tubing that ran out the door.. it was kind of short so when you opened the vavle the tubing who go all over the place like a firehose with no one holding onto it. it was kind of fun to play with once in a while i guess.
-
shawns fords
- Posts: 1111
- Joined: March 31, 2007, 11:34 am
- Location: Foxfield Colorado
- Contact:
Why don't you drain it into a plastic antifreeze container or windshield washer fluid container - something with a closed spout and just get in the habit of doing it regularly?
Mine is an upright and the drain is on the bottom. I drain it daily and have a big sponge underneath the valve that I let the water run into. Most of the time it's dry the next day when I drain it again. Summertime is more water.
Mine is an upright and the drain is on the bottom. I drain it daily and have a big sponge underneath the valve that I let the water run into. Most of the time it's dry the next day when I drain it again. Summertime is more water.
"If you don't want to stand behind our Troops, feel free to stand in front of them."
1964 Ford F100
1967 US Army M416
1964 Ford F100
1967 US Army M416
I gotcha. What about something like this: http://www.paragoncode.com/shop/compressor/
Possibly in addition to running that line outside.
Possibly in addition to running that line outside.
"If you don't want to stand behind our Troops, feel free to stand in front of them."
1964 Ford F100
1967 US Army M416
1964 Ford F100
1967 US Army M416

