Transmission Help
Transmission Help
I have a 302 with an FMX tranny and was wondering if i could put a C4 or C6 in it,,which is possible but would i have to change the drive shaft to do that??
- needmoretime
- Posts: 239
- Joined: July 12, 2006, 10:52 pm
- Location: Middletown,Delaware
C4 is your best bet. The early C4's 67 vintage have a 24 spline input shaft. All later models have a 26 spline. This won't matter if you get one with the convertor otherwise you will need to count splines if you order a convertor.
Driveshaft is measured center to center of each yoke. The machinest will calculate the length.
Driveshaft is measured center to center of each yoke. The machinest will calculate the length.
- 64 litl un
- Posts: 156
- Joined: October 9, 2006, 11:26 pm
- Location: Heart of Dixie
The FMX or late Cruiseomatic is a very good transmission and is real close kin to a C6. They are very heavy because most if not all have an iron case. I would consider getting the FMX rebuilt. It will be expensive but maybe not as much as a new transmission and the modifications to make it work.
A C-6 may go right in. If you can find one with the 302 pattern.
Its no big deal getting the drive shaft cut and rewelded for a different length and yoke. A machine shop or spring place can do that for you.
If I were you and I was planning to change from that FMX I would go with an AOD. Why do all that work and not have overdrive. Early AODs had some problems but they were soon corrected.
A C-6 may go right in. If you can find one with the 302 pattern.
Its no big deal getting the drive shaft cut and rewelded for a different length and yoke. A machine shop or spring place can do that for you.
If I were you and I was planning to change from that FMX I would go with an AOD. Why do all that work and not have overdrive. Early AODs had some problems but they were soon corrected.
I can drive it home with one headlight.
