SO I went out and took lots of pics. Of everything. Some subtle nuances, some things that may be of interest, others of lesser interest! haha
SO, lets begin, shall we???
relatively recent, not today- the light was really bad and a little dirty

the battery clamp I just made


73 econoline MC, wilwood prop. valve

Skip's swaybar conversion (Bronco 2) I think I will flip it around someday?

the headlight relays

rear fender braces I made from wagon axles

rear roll pan, didnt have somebody to light up the brake lights in the bed rolls. You can see the oily spots from what drafts up from the drippy engine. And I hate those tail lights. I want to french something into the roll pan...

erm, main leaky- the intake didnt seal right and it drips down on the pipe

my home made door panels

door pins and relay (needs a bolt) for dome light

auxiliary fuse boxes- put in when I removed a wad of wiring and inline fuses I put in years ago

the strange brake light switch I've mentioned recently

and this one shows the spring I put on the pedal to pull it off of the MC... it is about 1/8 inch from pressing on the brakes. I did this to make adjusting the light switch easier. The light was either staying on all the time or had to push too much brake before it came on. So I made it to where it will come on with just touching the pedal but not actually on the brakes.

hidden backup light switch

and indicator so I remember to shut it off

My repro Mirrors

and the one that points off toward casey65's...

the seatbelts- the backing plate goes all the way into the door and window frames.

you can see the mechanisms here

the backing for seatbelt mech

and the center backer. there is a chunk of a leaf spring that the bolts go thru.

the Rocket Box and assorted crap

the glove box box


extinguisher bolted down

note the terrible hole from PO that I need to weld up nice

and the grille I screwed down over the hatchet wound in the dash

the shitty steering column (damn I wish I had the rest of the stuff to swap out the steering with my Flaming River brushed SS column)

hiding antenna- not electric

terrible coverage when I painted hood

bad hinges

bad coverage on roof... wtf!

vent window rubber- 6 years old? already cracked all to hell

i finally got some nice period correct wipers

I hate this freaking gas tank

definitely not a factory switch

very not good. I need to modify the pan, and raise the drivetrain a few inches. the axle hits the pan and made a horrible crease

the sway bar also hits

I can raise drivetrain several inches without modifying floor

and a few without changing brake cylinder.

my current engine mount arms

these damned power lines were inducing some voltage on aggie and was shocking me during oil change- yeah I know it wasnt Aggie's fault, doesnt shock any where else. the lines buzz loudly!

So Sexy- except for them crappy tail lights!!!! grr!


you DONT want to meet her from this angle!!!!







